It has the following options make it so great.
It can move Forward/Reverse/Left/Right.
It has two speeds High/Low.
It has head movement left/right.
- Eye's light up
- Eye's light up to sounds played on it.
- Shoulder
- Elbow
- Wrist
- Fingers
On boad digital clock with alarm.
Remote has a microphone allowing projection of your voice into the robot.
Tape deck to play cassette or record.
- Programs
- Music
- 6 Volt Lead Acid Battery
- Two (2) "AA" batterys
This allows you to send commands to the robot.
*Without it you can't use the Robot.
Commands
- Power Switch On/Off
- Arm Control
- up/down
- wrist clockwise/counterclockwise
- Direction
- Forward
- Back
- Left
- Right
- Finger Open
- Finger Close
- Head Right
- Head Left
- Gear Change
- Tape Start/Stop
- Omnibot Sounds
- Light On/Off *Eyes
- Four (4) "AA" 1.5 Volt Alkaline
- 49.860 Mhz (US)
- 27.145 Mhz (EC)
- 40.680 Mhz (TAL)
It is inserted into the front of the robot.
When you hit the switch seen in photo to the right. All the rings seen in the middle of the tray will move. Clockwise
It also comes with a cover not shown.
Note: You must have it insterted into the robot and power switch turned on robot for it to work.
It is used as a reference point when you are programing the Omnibot 2000.
Size: 10" x 10"
Click on image to Enlarge.
* It is not a needed part
It is used to charge the Lead Acid Battery
Specs:
Input: 120VAC, 60 HZ, 7 Watts
Output: 6 VDC, 500mA
Center Post Negative
It is used to Power the Robot.
Specs:
Output: 6 VDC, 4.5 Ah
Physical Size: 2 3/4" L x 1 3/4" W x 4" H
Terminals/Connector: Leaded wires with "barrel type" connector.
Center Post Negative
A Inferred Sensor connects into back of the robot.
